And the panels haven't fallen off yet. Finding a damn keymod scout light mount is freaking impossible right now. The shavings at the screw driver is actually from a screw. . If for any reason you decide that your purchase just isn't for you, simply return the item within 30 days of receipt and we'll cover the cost of return shipping.
They look great, cant see the cuts unless you look for them and even then they are small and barley noticeable. Was this review helpful to you? Didnt work but on the right track. Originally Posted By cmc201: Using the wrong tool for the job and ruining parts has never been been my plan of attack. Each cover has rounded edges to eliminate snags and pinch points. This piece was my guinea pig on safe removal.
The bcm rail covers however aren't available for purchase despite being on the site for months. Just have to loosen to a thread and spin both nut and bolt in the direction you need. I used a fine threaded screw in attempt to raise the tabs. Such a practice is heavily regulated and subject to applicable laws. Locking tabs on either end, depending which direction they are installed. I run an Impact Weapons Components Scout keymod mount.
I like these covers but have a difficult time getting them on. Thanks, Dave Hmmm, I seemed to encounter a bit of an issue seating my mi covers but once I unscrewed it as far as possible and held the heads down it wasn't too difficult. Also make sure the keymod nuts are facing the proper direction. Finding a damn keymod scout light mount is freaking impossible right now. I tap them into place with a block of wood and hammer.
After a considerable amount of time spend trying to get them using methods mentioned above, and melting one in the microwave good thing it comes with 7 I was unable to get all six connections in at once. I've been keeping an eye on these bad ass rail covers also. Works well Originally Posted By cmc201: Using the wrong tool for the job and ruining parts has never been been my plan of attack. I do some rapid fire shooting and use a digital thermometer to test just how well they actually work! Heh yeah I had to get a few of the bcm keymod nuts myself for lost ones. I got them on pretty easily. Bcm puts stuff on their site a while before release and in the case of their rail covers they decided to completely redesign them in the last phase of development. Only had to screw in a tiny bit and they lifted well out of the way.
By viewing or flagging this video you are acknowledging the above. These videos are free to watch and if anyone attempts to charge for this video notify us immediately. Waiting for the short ones to come out. But they're cheap so whatever. From what I've heard they won't be available for months still. I found that three was manageable but not easy, so I cut them in half, making the cuts around the wrench shaped segment in the middle where the least amount of plastic is.